5
When installing thi s Mini-Bar Refrigerator, ventilation should be considered seriously, please referto the
following:
▪ There should be at least 200 cm³ for ventilation in total
▪ The following four pictures show four different installation ways
▪ This refrigerator is designed to be free standing, and should not be recessed or completely built-in (Fully
enclosed cupboard). Allow 5cm of space on the sides of the refrigerator, which allows the proper air
circulation required for good operation and a very minimum of 2cm on the back wall.
▪ Place your refrigerator on a surface that is strong enough to support it when it is fully loaded.
▪ Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly.
▪ This refrigerator uses thermoelectric refrigeration technology (no compressor) and is not designed for
storage in cold areas like garages, warehouses or outdoors
▪ Avoid locating the unit in moist areas.
▪ Plug the refrigerator into an exclusive, properly installed-grounded wall socket. Do not under
any circumstances cut or remove the third (ground) prong from the plug. Any questions concerning
power requirements please get in touch with the manufacturer.
▪ After plugging the refrigerator into a mains wall socket, allow the unit to cool down for at least 2-3
hours before placing items inside.
Thermoelectric Mini-Bar Refrigerator
To Next Page
Loading...
