9. Install the output jack assembly to
the guitar using four of the wood
screws supplied and as show in the
illustration below.
10. Route the wire toward the preamp
opening using the supplied cable
clips to secure the cable inside
the body.
11. Likewise route the pickup cable
toward the preamp opening.
12. Install a battery into the preamp
(see owner’s manual) and verify the
operation of the unit.
13. Insert the Breeze through the preamp
opening into the guitar to allow
cable connections to be made.
14. Firmly holding down the preamp
assembly in opening, Insert the
under-saddle pickup cable into
the preamp’s 2.5mm jack as shown
in the illustration.
15. In the same fashion, insert the output
connector into the 5-pin molex
connector. In the case of the Breeze
II, the mating connector has only
three pins. Mate this connector to
the middle three pins of the output
connector. This will leave one open
pin on either side of the jack.
16. If installing a Breeze IV system with
an auxiliary pickup, at this time
install the cable from this pickup
into the 3.5mm AUX jack, located
near the saddle pickup input.
17. Before attaching the trim plate and
preamp to the body of the guitar,
Confirm operation of the preamp by
plugging the guitar into an amp
or PA and testing all functions.
18. Finally, referring to the
illustration above, align the
preamp mounting tabs to the pilot
holes and use the four wood screws
provided to attach the preamp.
Insert the wood screws through the
preamp trim plate, mounting tabs,
and finally into the pilot holes.
Tighten until snug. The trim plate
will flex to adapt to the curve of
the guitar’s upper bout.
Notes:
Installation Guide
Barcus-Berry®
PO Box 63366, N Charleston, SC 29419 USA
www.barcusberry.com
Installation Guide
Barcus-Berry®
PO Box 63366, N Charleston, SC 29419 USA
www.barcusberry.com
To Next Page
Need help?
General
