Barrett 4050 HF SDR Installation Guide

1
BCM40531
Removing the Head
1. Invert the transceiver and use an appropriate tool to loosen (but not remove), the two front panel securing screws
located immediately behind the front panel.
2. Gently pull the front panel from the transceiver to remove it.
Opening the Transceiver Body
1. Remove the four cap head set screws securing the transceiver chassis halves together using an appropriately sized
allen key.
2. Carefully open the transceiver chassis halves as shown.
1
2
1 2
4050 DV/SDV Module Installation Guide
This guide outlines the installation and removal of a DV/SDV module from a Barrett 4050 transceiver. This should be
undertaken by a technical professional and proper care must be taken to ensure correct installation.

Barrett 4050 HF SDR Specifications

General

Frequency Range (Rx)	250 kHz to 30 MHz
Operating Temperature	-30°C to +60°C
Frequency Range (Tx)	1.6 to 30 MHz
Operating Modes	USB, LSB, AM, CW
RF Output Power	125 W PEP
Supply Voltage	13.8 V DC nominal (10.8 to 16 V DC)
Weight	1.5 kg