Bartec BCS 3608ex-NI - Page 26

Hand-held scanners
BCS 3600
ex
series
6 Operation
Subject to technical modifications
16/05/2018
25 / 28
6.3 Scanning
During scanning, the hand-held scanners in the BCS 3600
ex
series emit a scanner beam.
1. To scan a barcode, direct the scanner beam onto the barcode so that it captures the whole width of the
barcode. While doing so, pay attention to the optimal scan position (see Chapter 6.4, P. 26).
2. Align the hand-held scanner centrally on the barcode.
3. Press the trigger button.
 White LEDs on the hand-held scanner are switched on to illuminate the barcode.
 Scanner emits a beep to signalise the successful decoding of the barcode (see Chapter 4.2.1, P. Fehler!
Textmarke nicht definiert.).