- 26 -
Toasting
• Make sure that the mode control knob is at the ON/OFF position.
• Plug the device into the single socket.
• The green light illuminates.
• Using the speed control (left knob, positions 1-7) set the conveyor speed to the highest
(maximum speed) position 1.
• Set the mode control (right knob) to TOAST/BREAD and allow the device to warm-
up for approximately 15 – 20 minutes.
Available modes:
upper and lower heating = TOAST/BREAD
upper heating = BRÖTCHEN/BUNS
BEREIT/STBY = standby
• Place two bread slices on the conveyor belt using the toast feed rack and toast them
to test the setting. The higher the conveyor belt speed, the lighter browning of the
toast. After toasting the toast is discharged at the rear of the device and slides down
the toast discharge chute.
NOTE
!
To toast moist bread products, such as English muffins, rye bread or wholegrain
bread, reduce the conveyor belt speed by turning the speed control knob (clockwise)
to the higher position.
• For best result set the conveyor belt speed to middle positions (3 – 4).
• Bread/ toast slices or buns can be placed directly on the conveyor belt. The toast
feed rack should be fully inclined.
• When the device is not in use, you can turn the mode control to BEREIT/STBY
position to set the device to its standby, energy-saving mode. The device will use
only 25% of the available power.
NOTE
!
To reset the device to its working mode, set the mode control to TOAST/
BREAD or BRÖTCHEN/BUNS. The device is ready to use within 5 minutes.
To Next Page
Loading...