Quick Reference Guide
Lisa
© 2021
basalte v1.0
F
E
C
A
B
D D
A
B
C
D
E
F
Proximity & light sensor
Reset button
USB
Microphones
Speaker
LAN+Power over Ethernet
Lisa is designed to be wall mounted.
Lisa requires a minimum mounting depth of 24mm from
the back side of Lisa plus room for cable/s. Power is
supplied by Power Over Ethernet (PoE). PoE must meet the
IEEE 802.3af standard. Lisa connects to the local network
via a hard wired Ethernet connection.
The recommended mounting height for Lisa is
1450 mm -1650 mm (57”- 65”) above the finished floor.
1 Installing Lisa
a. Mounting height
1450 mm / 57”
1650 mm / 65”
b. Rough-In
EU/CH single-gang box
UK single-gang steel boxUK standard single-gang box
EU/CH single-gang box
c. Mounting
EU/CH single-gang junction box:
Take off the 2
original screws
of the gang box
before mounting!
d. Installing the mounting bracket
Take off the 2
original screws
of the gang box
before mounting!
UK standard single-gang:
e. Connecting Lisa to power and Ethernet
PoE Injector
PoE Network Switch
Network Switch
To Lisa
f. Installing Lisa on the wall
Push
Top of
single-gang Box
Mounting Bracket
Dry Wall LockedDry Wall
Top of
single-gang Box
Mounting Bracket
g. Mounting Lisa
Align the mounting bracket hooks with the mounting
slots and gently press Lisa towards the mounting
bracket/wall.
Make sure the mounting hooks are properly engaged.
Lisa has been designed to mount to a EU/CH single-gang
junction box, UK standard single-gang junction box or
steel box.
The mounting bracket, included in the box, should be
attached with included screws (2x #5-24).
Install the single-gang box junction box in its
normal orientation.
Using the included #5-24 screws to mount the mounting
bracket onto the EU/CH single-gang junction box, UK
standard single-gang junction box or steel box.
PoE Connection
PoE connection requires the IEEE 802.3af standard.
Use a network switch or PoE injector that meets this
standard.
Connect Lisa using a standard T568A or T568B Ethernet
cable from the network switch to the LAN/PoE connector
on the back of Lisa.
Position Lisa for mounting, align the mounting bracket
hooks with Lisa mounting slots and gently press it
towards the mounting bracket/wall.
Lisa snaps in when pushed to its mounting bracket.
CAUTION: DO NOT PRESS DIRECTLY ON THE SCREEN
When installing on to the mounting bracket. Press only
on the frame edges.
2x #5-24
UK single-gang box
D
To Next Page
Need help?
General
