BASEPUMP RB750-EZ - Mount the Float Valve; Connect Water Line; Install the High Water Alarm

Mount the Float Valve to the suction pipe and connect the transfer tube.
 Simple mounting, no special tools required.
 Tools: Screw driver
 Materials Required: none
 10 Minutes
Mount the Float Valve
Connect Water Line by inserting the tee into a cold
water line and pipe to the Basepump.
 The water line can be piped with copper, PEX, or CPVC
tubing. Basepump EZ & PRO models include ¾” push
connection solder-free fittings.
 Tools: Tube cutter, tape measure
 Materials Required: ¾” Copper, PEX, or CPVC tubing.
 60 Minutes
C
o
n
n
Connect Water Line
Install the high Water Alarm.
 Alarm & float switch easily mounts to the suction pipe, all hardware included.
 Tools: Screw driver
 Materials Required: none
 10 minutes
A) Cost of the Basepump: $____________________
B) Cost of the additional materials: $______________
C) Estimated installation time: ________Hours x $_________ per hour = $_______________
Total estimated project cost: $___________________________
Note: The above installation times are based on actual estimates from professional plumbers using a typical
installation. These are only estimates. Long runs of water piping, sump pit configuration, small enclosed areas, etc. will
affect the installation time.