c) LED light
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with
optical instruments!
d) LiPo Battery
• The rechargeable battery is permanently
built into the product and cannot be replaced.
• Never damage the rechargeable battery.
Damaging the casing of the rechargeable
battery might cause an explosion or a re!
Unlike conventional batteries/rechargeable
batteries (e.g. AA or AAA type), the casing
of the LiPo rechargeable battery does not
consist of a thin sheet but rather a sensitive
plastic lm only.
• Never short-circuit the contacts of the
rechargeable battery. Do not throw the
battery or the product into re. There is a
danger of re and explosion!
• Charge the rechargeable battery regularly,
even if you do are not using the product.
Due to the rechargeable battery technology
being used, you do not need to discharge
the rechargeable battery rst.
• Never charge the rechargeable battery of
the product unattended.
• When charging, place the product on a
surface that is not heat-sensitive. It is
normal that a certain amount of heat is
generated during charging.
• Before charging the battery, make sure
that the USB power source can deliver
sufcient current, otherwise you may
damage the source. Do not use a USB
port of a computer, keyboard or USB hub
without a power adapter as the current
supplied by these ports is insufcient.
Operating elements
Item No. 2109094 shown below.
1
2
3
5
6
7
8
9
4
11
12
13
14
10
1 Ring light dimmer
2 Camera cable
3 Camera body
4 Camera lens LED ring
light
5 Charging cable
6 Lens sealing cap
7 Mirror tip
8 Magnetic tip
9 Hooked tip
10 Power indicator light
11 Wi-Fi box power button
12 Status indicator
13 MicroUSB charging port
14 USB-A camera input
Charge the Wi-Fi box battery
Connect one end of the charging cable (5) to the MicroUSB charging port (13), and the other
end to a suitable power supply.
The status (12) indicator will light red when charging and go off when the battery is fully charged.
The status indicator will ash blue when the battery is low.
Adjust LED brightness
Use the ring light dimmer (1) to (increase “+” or decrease “-”) the brightness of the
LED ring light (4).
Use with mobile device
a) Setup
1. Visit the App or Google Play store and download the “HD wi Endoscope” app by Basetech.
2. Connect the endoscope to the USB-A camera input (14) on the Wi-Fi box.
3. Press and hold the power button (11) to turn the Wi-Fi box on.
• Press and hold the power button to turn it off again.
4. The name of the endoscope Wi-Fi is:
- Item No. 2108950: BASETech BSK-2035
- Item No. 2109094: BASETech BSK-2100
5. After connecting to the endoscope Wi-Fi, launch the app. The camera image appears on
screen.
If the following message pops up: “... No data connection. Allow Wi-Fi assistant to
switch the network to a better one?” select “Decline”.
Operating Instructions
Wi-Fi Endoscope
Item No. 2108950 (BSK-2035)
Item No. 2109094 (BSK-2100)
Intended use
The product is suitable for optical
troubleshooting or inspection of pipe systems
as well as powered-down (voltage-free)
systems and facilities. The water resistance
only applies to contact with liquids (no acids
or alkaline solutions). It is forbidden to use
the product on people and animals and in
potentially explosive environments.
The camera lens and body have an ingress
protection rating of IP67. They are protected
against dust and submersion in water up to
1 meter deep for 30 minutes. It is
recommended to use the included lens
sealing cap for increased protection against
water ingress. Do not get the dimmer, USB-A
connector or Wi-Fi box wet. There is a water
level sticker on the cable (between the camera
body and dimmer) which indicates where the
IP protection starts and stops.
For safety and approval purposes, you must
not rebuild and/or modify this product. If
you use the product for purposes other than
those described above, the product may be
damaged. In addition, improper use can result
in short circuits, res, electric shocks or other
hazards. Read the instructions carefully and
store them in a safe place. Make this product
available to third parties only together with its
operating instructions.
This product complies with the statutory
national and European requirements. All
company names and product names are
trademarks of their respective owners. All
rights reserved.
Delivery content
• Endoscope
• Wi-Fi box
• Lens sealing cap
• 3x attachments:
(hook, magnetic, mirror)
• Charging cable
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the
website.
Explanation of symbols
The symbol with the lightning in the
triangle is used if there is a risk to
your health, e.g. due to an electric
shock.
The symbol with the exclamation
mark in the triangle is used to
indicate important information
in these operating instructions.
Always read this information
carefully.
The arrow symbol indicates
special information and advice on
operation.
Safety instructions
Read the operating instructions
carefully and especially observe
the safety information. If you do not
follow the safety instructions and
information on proper handling
in this manual, we assume no
liability for any resulting personal
injury or damage to property.
Such cases will invalidate the
warranty/guarantee.
a) General information
• The device is not a toy. Keep it out of the
reach of children and pets.
• Do not leave packaging material lying
around carelessly. This may become
dangerous playing material for children.
• Protect the appliance from extreme
temperatures, direct sunlight, strong jolts,
high humidity, moisture, ammable gases,
steam and solvents.
• Do not place the product under any
mechanical stress.
• If it is no longer possible to operate the
product safely, take it out of operation and
protect it from any accidental use. Safe
operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in
poor ambient conditions or
- has been subjected to any serious
transport-related stresses.
• Please handle the product carefully. Jolts,
impacts or a fall even from a low height can
damage the product.
• Consult an expert when in doubt about
the operation, safety or connection of the
appliance.
• The use of electrical devices must be
supervised by trained staff in schools,
training centers, hobby and do-it-yourself
workshops.
• In industrial facilities, heed all applicable
accident prevention regulations for
electrical installations and equipment.
• Maintenance, modications and repairs
must only be completed by a technician or
an authorised repair centre.
• If you have questions which remain
unanswered by these operating
instructions, contact our technical support
service or other technical personnel.
b) Endoscope
• The endoscope is suited for inspection
only in voltage-free systems. The
camera head is made of metal and can
cause short-circuiting.
• For safety reasons, make sure all
system components are voltage-free
before inspection.
• Hold the camera neck and head only in
voltage-free liquids. Do not submerge
the camera neck past the “max. water
level” mark.
• Avoid heavy mechanical loads and/or
vibrations. Do not exceed the minimum
bending radius of 30 mm.
To Next Page
Need help?
General
