Basic American ZENITH Series - Unpacking the Bed Components

Basic American Medical Products, a division of GF Health Products, Inc. www.grahamfield.com 999-0831-190A Service Manual
9
Zenith aps seRies
UNPACKING YOUR BED
•
Make sure all parts/components are included.
•
Check all bed components for obvious damage.
•
Inspect the Power Supply Cord for any cuts
and/or damage.
•
Check to see all actuator/motor cables are routed
and connected properly to the control box.
DISCARD
1. Cardboard Blocks
2. Large Block
3. Large Cable Tie - CUT
4. Notched 2 x 4 Board
5. Foam Wrapping
6. End Caps with Foam
7. Notched Leg Foam
8. Small Cable Tie - CUT
KEEP
9. Wireform Wallsaver
10. Two Mattress Retainers
11. Service Manual/Documents
12. Wallsaver Adaptor Brackets for
Trendelenberg and Reverse
Trendelenberg Positioning
13. Pendant Holster
(attached to pendant)
NOTE: END OF POWER CABLE
IS COILED FOR SHIPPING AND
TIED, WITH CABLE TIE, TO GRID
WIRE ALONG WITH PENDANT,
PENDANT CABLE & HOLSTER.
PLEASE CUT AND DISCARD
CABLE TIE AROUND CABLES
WHEN YOU UN-PACK YOUR BED.
ALSO
DISCARD TOP
AND BOTTOM
CARTONS
1
2
5
6
6
4
7
10
10
8
9
7
12
11
13
3
Cut and
discard
cable tie.
NOTE:
Underbed Light is optional and available on
APS981741 Models.
Underbed Light and Mounted Battery optional
combination is available on APS981742 Models.