- 6 -
INSTALLATION GUIDE
*For assemblies including ange nuts (intergrated washer nuts), you will not have at washers in your kit.
1
CHOOSE YOUR SPOT
Choose a location that allows a
stake to be pushed in and that
is located directly behind a solid
surface such as pavement or a
concrete curb.
1.1 1.2
2
MAKE A PILOT HOLE
Make a pilot hole about 60 cm
(24 in.) deep using a pinch point
crowbar or a steel rod. Try to
insert it in the ground as straight
as possible. If you run into an
obstacle in the ground, you will
have to nd another spot for the
installation of PROBASE.
2.1
3
ASSEMBLE THE STAKE
Assemble the two components
of the stake (A) using 5 bolts (J),
5 at washers* (L) and 5 nuts (K).
Tighten the bolts rmly.
3.1 3.2 3.3
To Next Page
Loading...