Junior II WT
Page 16 1st ed. Rev 0 Chg 3
BAUER
COMPRESSORS
3.3.6 Changing the 3rd Stage Valves
On this valve head, the valves are arranged on the upper and lower side due to the small diameter of the
3rd Stage head. See Figure 3-8.
1. To remove or install the intake valve (6) use the special tool which is part of tool set delivered with
the unit. (See Figure 3-16.)
2. The pressure valve (3) is merely inserted into the valve head (5). It is sealed by the O-Ring (4) and
fixed to the valve head by the torque stud (1).
3. Remove pressure valve by loosening torque stud (1) a couple of turns.
Figure 3-8 3rd Stage Valve Head
1. Torque Stud
2. Valve Cover
3. Pressure Valve
4. O-ring
5. Valve Head
6. Intake Valve
7. Allen Screw
8. Washer
^ CAUTION ^
Always change the intake and pressure valves of the 3rd Stage at the same time.
1
2
3
4
5
6
7
8
To Next Page
Loading...
