ImVT 120 II Mini Verticus
Page 96 1st Edition, Rev. 0 Chg. 10
8.4 DIGITAL PRESSURE SWITCH
A digital pressure switch (Bauer P/N SWT-0282) is being used for this application. This switch has a
three digit digital display on the face that displays the real time pressure in the line. The display can
only show three digits but Bauer’s application for the switch is in the thousand psi range. The switch is
set up to read pressure times 10, i.e. the display reads 345 for 3,450 psi. The switch set points will be
programmed by our test department. After the switch is set in test it is then locked out so that the set
points can not be accidentally changed.
8.5 PROGRAMMING THE PRESSURE SWITCH.
1. Press the mode key (3) one time to enter the menu.
2. Press the up or down arrow keys (4) to scroll through the menu. (Some of the menu features are not
being used for the Bauer Compressor application. Please ignore these menus.)
3. Press the mode key (3) one time to enter that menu selection in order to adjust its values.
4. When programming is complete press and hold the mode key (3) for five seconds. The new setting
is saved when u3.2 is displayed.
Figure 8-3 Digital Pressure Switch
1. Electrical Connector
2. Display
3. Mode Switch
4. UP and DOWN Switches
1
2
3
4
To Next Page
Loading...
