ImVT 120 II Mini Verticus
Page 2 1st Edition, Rev. 0 Chg. 10
1.2 How to Use the Replacement Parts List
• A lozenge ♦ in the Item Number column indicates the part number for a complete assembly.
• a dagger (†) in the Qty column with or without an ellipse (…) in the Part Number column means the
part is illustrated for assembly purposes only and is not available for sale as an individual component.
This part can be obtained by ordering the complete assembly.
• AR in the Qty column means that the item is cut or manufactured to the size which the customer spec-
ifies.
• A dash (—) in the Item Number column indicates that there is more than one part number applicable
to the preceding Item Number.
• The letters in the columns labeled Kit indicate the number of operating hours when the part is to be
replaced; a = replaced every 1,000 hours, b = replaced every 2,000 hours and c= replaced every 4,000
hours.
• NS in the Item Number column indicates the part is not illustrated but is available.
When placing an order for spare parts, please provide the following information to ensure delivery of the
correct parts. The model number, date of manufacture and serial number can be found of the compressor
unit identification plate on the compressor unit frame.
Information Example
Model Number TCom-25
Serial Number 32165
Date of Manufacture 02/2005
Quantity required 2
Part Number N04860
Part Description Valve
Figure 1-1 Compressor Identification Plate
BAUER
COMPRESSORS
BAUER COMPRESSORS, INC.
NORFOLK, VIRGINIA U.S.A
LBL-004
MODEL NO.
BLOCK NO.
CAPACITY
CFM
CHG. RATE
CFM
MOTOR HP
SPEED
RPM
SERIAL NO.
PRESSURE
PSIG
VOLTS
PH
HZ AMPS
DATE OF MANUFACTUREDATE OF MANUFACTURE
To Next Page
Loading...
