ImVT 120 II Mini Verticus
Page 62 1st Edition, Rev. 0 Chg. 10
5.4 Maintenance
5.4.1 Oil and Water Separator
To remove the sintered metal filter proceed as follows: (See Figure 5-7). Disconnect the power and shut
off the inlet supply line if applicable.
1. Depressurize the system by means of the bleed valve.
2. Remove the tubes connected to the side of the filter head (1).
3. Unscrew and remove the filter head.
4. Unscrew the sintered metal filter (2) from the filter head.
5. Remove the center screw (3) to remove the sintered metal filter.
6. Clean the sintered metal filter using hot soapy water. Blow dry with compressed air.
7. After cleaning the element, record the number of operating hours to ensure exact attention to the
maintenance intervals.
8. Lubricate the threads and O-rings as well as the threaded part of the sintered metal filter with petro-
leum jelly. Apply sparingly.
9. Dry the inside of the filter housing with a clean cloth and check for corrosion before reinstalling the
sintered metal filter.
10. In the event you discover corrosion, replace the corroded parts with new BAUER parts.
11. Reinstall the sintered metal filter assembly and filter head.
12. Replace all removed tubes, close all valves and check for leaks.
Color State Indication Compressor Unit Status
Green Steady Satisfactory The unit is in operation
Yellow Flashing Cartridge Change Pre-warning The unit is in operation. The green
LED will also illuminate.
Red Flashing Cartridge Change Required The unit is shutdown and can not be
started until the cartridges are
changed.
Red Steady Cable Failure or Missing Cartridge The unit is shutdown.
No LEDs Illuminate No operating voltage or electronic failure The unit is shutdown.
To Next Page
Loading...
