Page 10 =.%'#$*+(2*"/'>3$-#2.(-?'0/$"-$'*"//'@ABBBABCCADEFE8
Item 64996
GH=;IJ KL;MHINKO PHNOI;OHOQ;HGG;P!RJ
K0$%"#2.(
IK'LM;1;OI'G;MNKVG'NOdVMJ'HOU'U;HI]6
e' S$"%'HOGNA"00%.Y$)'-"9$#&',.,,/$-?'+"%)'+"#'"()'-#$$/A#.$)'5..#-')3%2(,'3-$8
e' HY.2)'W2*W'5"*W8''U.'(.#'#.3*+'T32)$'!"%'#20'#.'"(&'.5X$*#8''Tip contact
may cause guide bar to move suddenly upward and backwards.''
• U.'(.#'.0$%"#$'L./$'G"4'42#+'.($'+"()8 Only hold Pole Saw with both
hands. Do not stand directly under branch being cut.
• K(/&'-#"()'.('92[$)?'-$*3%$'"()'/$Y$/'-3%9"*$. Do not stand on a ladder or other support.
• U.'(.#'.0$%"#$'42#+2('D_'9$$#'.9'$/$*#%2*"/'/2($-8
!;=KM;';1;MJ'VG;6
a. Check oil level, add oil as necessary f-$$'
=2//'H3#.:"#2*'K2/$%'M$-$%Y.2%'.('0",$'Bg8
b. Confirm proper Extension Lock operation
f-$$'H)X3-#'L./$'G"4'R$(,#+'.('0",$'Bg8
c. Run Pole Saw at half throttle for several
minutes f-$$'-#$0'h8'5$/.4g8
d. Stop motor and remove Battery Pack8
R$#'*+"2('*../? then check tension
and adjust as necessary f-$$'
I$(-2.('G"4'Q+"2('.('0",$'Bg8
e. Make sure Saw Chain is sharp.
f. Make sure Automatic Oiler is distributing oil.
UVMNOT';1;MJ'VG;6
a. Check tension often during the first half
hour of use and periodically during use.
Adjust tension as necessary f-$$'
I$(-2.('G"4'Q+"2('.('0",$'Bg8
b. Check oil level every 10 minutes of
use. Fill oil reservoir as needed f-$$'
=2//'H3#.:"#2*'K2/$%'M$-$%Y.2%'.('0",$'Bg8
1. Loosen Shoulder Strap, then place over
shoulder. Tighten Shoulder Strap, making
sure shoulder pad is on top of shoulder.
2. Adjust Pole Saw length as desired.
3. To start, push and hold Trigger Safety Lock,
then squeeze and hold Trigger.
Release Trigger Safety Lock.
To stop, release Trigger.
4. Maintain a firm grip, with thumbs and fingers
encircling the Pole Saw’s handle and pole, with
both hands on the saw and position your body
and arm to allow you to resist kickback forces.
5. Hold the Pole Saw to the side of your body at
maximum 60° from horizontal. Do not overreach.
6. Make sure Saw is running at full
speed before starting a cut.
7. Cut lower branches first.
8. Do not force Pole Saw, let Pole Saw do the work.
9. Remove the Pole Saw from a cut while it is running.
To Next Page
Loading...