Page 13=.%'#$*+(2*"/'>3$-#2.(-?'0/$"-$'*"//'@ABBBABCCADEFE8
Item 64996
GH=;IJKL;MHINKOPHNOI;OHOQ; HGG;P!RJ
G+"%0$(2(,7M$0/"*2(,'G"4'Q+"2(
1. Have the cutters sharpened by a
qualified technician when:
a. The sawdust becomes powder-like.
b. You can’t make the cut without extra force.
c. The Pole Saw does not cut straight.
d. Vibration increases.
2. A Saw Chain that is damaged or too worn to be
restored by sharpening will need to be replaced.
SHMONOT\''I+2-'#../'*.:$-'42#+'$2#+$%'
K%$,.('F_'.%'F@'T32)$'!"%'"()'G"4'Q+"2(8''
S+$('%$0/"*2(,'G"4'Q+"2(?':"W$'-3%$'#+$'
%$0/"*$:$(#':"#*+$-'#+$'T32)$'!"%8'
M$0/"*2(,'U%2Y$'G0%.*W$#'
Have the Drive Sprocket replaced by a qualified technician when the Saw Chain is replaced.
U$#$%:2(2(,'T32)$'!"%'S$"%
The rails of the Guide Bar groove should
always be parallel to each other. Place a
ruler along the side of the Guide Bar and
Saw Chain. If there is a gap, the bar is normal.
G#%"2,+#'
T32)$'!"%
M3/$%
M"2/
G"4'
Q+"2(
T"0
If the ruler is flush with the Guide Bar and
Saw Chain, or the Chain tilts to one side, then the
Guide Bar is worn and needs to be replaced.
M3/$%
S.%('
T32)$'!"%
I2/#2(,'G"4'
Q+"2(
To Previous Page
Loading...