Bauer 19115C-B - Assembly; Installing the Guard; Installing the Wheel Assembly

Page 8 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 64995
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
F##*5+7V
GI%JK6!6MG%E6KLIPE%LMePKH%;KIN%FOOLU6MGFT%IJ6KFGLIM-%N,X*%#'(*%$.,$%$.*%G("33*(%"#%"8%
$.*%&22?/&#"$"&8%,89%(*5&W*%$.*%S,$$*(V%J,4X%+*2&(*%/*(2&(5"83%,8V%/(&4*9'(*%"8%$."#%#*4$"&81
M&$*- For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
L8#$,77"83%R',(9
QFKMLMRf%%GI%JK6!6MG%E6KLIPE%LMePKH%
;KIN%;THLMR%U6SKLE%FMU%JL6O6E%I;%
GKLNNLMR%TLM6-%L8#$,77%$.*%3',(9%
&87V%"8%$.*%&("*8$,$"&8%#.&)81
1. Align the Guard with the bottom of the
Trimmer Head as shown in Figure A. Slide
the tabs on the Guard into the slots on
the bottom of the Trimmer Head.
2. Turn the Trimmer upside down and secure
the Guard to the Trimmer Head using the
Attachment Screw provided. Do not overtighten.
R',(9
F$$,4.5*8$%
E4(*)
!"*)%2(&5%
'89*(#"9*
;"3'(*%F
L8#$,77"83%Q.**7%F##*5+7V
The Wheel Assembly may be installed in one of three optional positions to use the tool
for forward and reverse trimming, side to side trimming, or edging procedures.
693*(%Q.**7%E*$'/
1. Slide the Wheel Assembly down
onto the Metal Plate located on the
side of the Trimmer Head. Make
sure the Wheel Assembly locks onto
the Plate – it will click into place
when properly installed.
2. Remove the Wheel Assembly
by pushing in on the Tab and
pulling up on the Wheels.
Q.**7%
F##*5+7V
N*$,7%
J7,$*
G,+
;"3'(*%S%