Page 10 ;&(%$*4.8"4,7%H'*#$"&8#>%/7*,#*%4,77%IJKKKJKLLJMNON1 Item 57180
FB;6PQ RS6=BPTRU VBTUP6UBUW6F6P?S
W&8$,4$%B4$',$"&8%V*4.,8"#5%[*2"8"$"&8
The contact actuation mechanism allows rapid placement of fasteners. Use the switch next to the LED
Indicator to change modes. The tool should only actuate if the Workpiece Contact is pressed against the
workpiece and the Trigger is pulled. It should actuate again if the Trigger is released and pulled OR if the
Workpiece Contact is lifted and pressed against the workpiece again. The tool should not actuate if the
Workpiece Contact is not pressed against an object. W&8$,4$%B4$',$"&8%#.&'79%&87D%+*%*8,+7*9%,89%
'#*9%+D%#]"77*9%&/*(,$&(#%).&%,(*%,),(*%&2%$.*%.,h,(9#%,89%'#*%/(&/*(>%#,2*%)&(]%/(,4$"4*#1
W&8$,4$%B4$',$"&8%V*4.,8"#5%P*#$"83%S(&4*9'(*
PR%S=6!6UP%F6=TR?F%TUi?=Q%;=RV%BWWT[6UPBZ%[TFWCB=Y6-%
S&"8$%$.*%$&&7%,$%,%/"*4*%&2%#4(,/%)&&9%).*8%$*#$"831
1. Disconnect the Battery Pack from the tool.
2. Load the magazine with fasteners.
3. Check that the Trigger and the Workpiece
Contact move freely, without sticking.
4. Connect the Battery Pack to the tool
making sure it clicks in place.
5. Set Activation Switch to the right
(contact actuation).
6. Test the tool by pressing the Workpiece Contact
against the workpiece without pulling the Trigger.
P.*%$&&7%5'#$%8&$%4D47*%E,4$',$*G1
If it cycles (actuates), stop immediately and have
it repaired by a qualified service technician.
7. Hold the tool away, or off of the workpiece.
The Workpiece Contact should return to its original
position. Squeeze the Trigger.
P.*%$&&7%5'#$%8&$%4D47*%E,4$',$*G1
If it cycles (actuates), stop immediately and
take the tool to a qualified service technician.
8. Press the Workpiece Contact against the workpiece
and squeeze the Trigger.
P.*%$&&7%5'#$%4D47*%E,4$',$*G%&87D%&84*1
Release the Trigger, slide the nailer to a fresh piece
of wood, and squeeze it again.
P.*%$&&7%5'#$%4D47*%E,4$',$*G%,3,"8%&87D%&84*1
With the Trigger depressed, carefully lift the tool
and press it against the workpiece again in a new
location.
P.*%$&&7%5'#$%4D47*%E,4$',$*G%,3,"8%&87D%&84*1
If it fails to act in the manner explained in bold,
have it repaired by a qualified service technician.
F)"$4.,+7*%P("33*(
PR%S=6!6UP%F6=TR?F%TUi?=Q%;=RV%BWWT[6UPBZ%[=T!TUY-
• =*7*,#*%P("33*(%,89%/&"8$%$&&7%"8%,%#,2*%9"(*4$"&8%+*2&(*%4.,83"83%,4$',$"&8%5&9*1
• RUZQ%&/*(,$*%$.*%$&&7%)"$.%$.*%F)"$4.%2'77D%"8%&8*%&2%$.*%,4$',$"&8%5&9*%/&#"$"&8#.
1. Set the Activation Mode Switch to the right
to enable Single Sequential operation
for precise placement of fasteners.
2. Set the Activation Mode Switch to the left to enable
Contact Actuation operation for rapid placement of
fasteners.
R87D%,%#]"77*9%&/*(,$&(%).&%"#%,),(*%&2%$.*%
.,h,(9#%,89%'#*#%/(&/*(>%#,2*%)&(]%/(,4$"4*#%
#.&'79%'#*%W&8$,4$%B4$',$"&8%&/*(,$"&81
F"837*%F*H'*8$",7% W&8$,4$%B4$',$"&8%
B4$"\,$"&8%V&9*%F)"$4.
To Next Page
Loading...