Page 9For technical questions, please call 1-888-866-5797.Item 58214
SAFETYOPERATIONMAINTENANCE SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Setting and Testing
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Adjusting the Auxiliary Handle
The Auxiliary Handle can be placed in a variety of
positions to obtain an efficient working angle.
1. To adjust the Auxiliary Handle, turn the Handle
counterclockwise to loosen the Band.
2. Slide the Handle on or off the Rotary Hammer
or to the desired position then turn the
Handle clockwise to secure it in place.
Using the Depth Gauge
The Depth Gauge can be used to lock in a desired
depth and return to that depth setting with ease.
1. Press the Gauge Lock Button, then slide
the Depth Gauge through the Depth
Gauge Slot on the Auxiliary Handle.
2. Position the Depth Gauge as needed, then release
the Lock Button to secure the Depth Gauge in place.
Adjusting the Functions
Adjust the Mode Selector to the desired function before
using the Rotary Hammer. Press the Release Button
and rotate the Mode Selector until it clicks in place
with the Indicator pointing to the desired function.
NOTICE: Move the Mode Selector only when the
Motor is stopped. Attempting to move the Mode
Selector while the Motor is engaged will result in
abrupt bit rotation and can cause property damage.
NOTICE: When moving the Mode Selector,
make sure it clicks into the desired position. If
not locked in place, the Mode Selector could
slip out of position resulting in tool damage.
To Chisel: Rotate the Mode Selector to the Hammer
Mode setting. The tool will hammer when powered.
To Rotate a Bit: Rotate the Mode Selector to
the Rotation Mode setting when rotating a bit.
To Hammer/Drill: Rotate the Mode Selector
to the Hammer/Drill Mode setting. The
tool will hammer drill when powered.
To Drill: Rotate the Mode Selector to the Drill
Mode setting. The tool will drill when powered.
Release
Button
Mode
Indicator
Hammer/Drill
Mode
Drill
Mode
Hammer
Mode
Rotation
Mode
To Next Page
Loading...