Page 11;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 57744
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
R*8*(,7%L8#$('4$"&8#%2&(%P#*
N,#&8(V%U("77"83%I/*(,$"&8
1. Adjust the Auxiliary Handle as needed.
2. Set the Function by adjusting the Mode
Selector to the desired setting.
3. Plug in the Power Cord.
4. Use the Directional Switch to select either a
clockwise or counterclockwise direction for the bit.
5. Squeeze and hold the Trigger to
turn on the Rotary Hammer.
6. Do not apply excessive force, allow
the tool to do the work.
O&84(*$*%U("77"83%G"/#-
a. Do not add water to the drill hole.
b. Clean the bit flutes regularly while drilling.
c. Back the bit out of the hole often during drilling,
especially when drilling deep holes.
d. Grease the bit shank and bit holder and keep
the shank end of the bit dust and debris free.
e. Use the shortest bit practical.
f. When drilling deep holes, work in stages,
use a short bit for the beginning of the hole,
then change to a longer bit.
_,55*(%U("77%I/*(,$"&8
1. Adjust the Auxiliary Handle as needed.
2. Set the Function by adjusting the Mode Selector to
the desired setting. Adjust the speed as needed.
3. Plug in the Power Cord.
4. Use the Directional Switch to select either a
clockwise or counterclockwise direction for the bit.
5. Squeeze and hold the Trigger to
turn on the Rotary Hammer.
6. Do not apply excessive force. Allow
the tool to do the work.
7. Q.*8%2"8"#.*9, to prevent accidents, release the
Trigger and disconnect its power supply after use.
a. Allow the bit to cool then remove it from the tool.
b. Wipe off the bit’s shank and store
bit separately from tool.
c. Clean the tool, then store the tool
indoors out of children’s reach.
O."#*7"83
O."#*7%I/*(,$"&8
1. Adjust the Auxiliary Handle as needed.
2. Set the Function by adjusting the Mode Selector to
the desired setting. Adjust the speed as needed.
3. Plug in the Power Cord.
4. Use the Directional Switch to select either a
clockwise or counterclockwise direction for the bit.
5. Squeeze and hold the Trigger to
turn on the Rotary Hammer.
6. Allow the Rotary Hammer to reach full speed
before contacting the work surface.
7. Q.*8%2"8"#.*9, to prevent accidents, release the
Trigger and disconnect its power supply after use.
a. Allow the bit to cool then remove it from the tool.
b. Wipe off the bit’s shank and store
bit separately from tool.
c. Clean the tool, then store the tool
indoors out of children’s reach.
To Next Page
Loading...
