Thank You for purchasing the

Bauer NE

.. We have developed the

Bauer NE

with the idea to increase your

convenience and security. We are a family owned company with over 50 years of service in the locking

hardware industry, and we are grateful for the opportunity to serve you. Please review and follow the

Installation, Programming, and Operating Instructions to ensure proper function.

The

Bauer NE

features:

 The first self-contained electronic RV latch with Capacitive Touch Technology.

 An integral touch pad to the latch which controls the dead bolt.

 It is powered by 4 AA batteries.

 Is retrofitable in most RV entry doors, and is easy to install.

 Programmable with a 4 digit PIN number.

 The large buttons are easy to see and use.

 Proximity sensing which illuminates the buttons.

 An Intelligent Keyless Entry System which knows the position of the deadbolt and indicates low

battery strength, as well as providing audible feedback to successful locking and unlocking functions.

 The key will always be able to operate the paddle or dead bolt lock in case of the user forgetting the

code or dead battery

Bauer NE

Installation Instructions:

 The following steps are graphically shown on the enclosed

Bauer NE

Installation schematic.

1. Remove old lock.

2. Clean cut-out. Remove any dirt, loose material, etc.

3. Install outside housing (the portion that includes the Touch Pad) with the dead bolt in the

unlocked position.

4. Attach the (2) 8x32 screws into the portion of the handle that has the Plunger and Dead

Bolt. This is on the edge of the door.

5. Plug wire from Inside Plate Assembly into the receptacle on the housing. DO NOT PICK UP

INSIDE PLATE ASSEMBLY BY PLUG. Make sure to align the tab on the plug properly with

the slot on the receptacle. The plug should make a slight click when properly engaged.

6. Tuck Battery Wires into pocket next to Stamped Steel Plate. Do not allow Battery Wires to

get between Inside Plate Assembly and Stamped Steel Plate as it will cause the motor to

bind.

7. Align the Dead Bolt Knob in the unlocked position. The Red Dots on the Dead Bolt Knob

and the Inside Plate Assembly should be aligned to indicate the unlocked position of the

Dead Bolt. Slide Dead Bolt Knob over D-Stem and align the 4 screw bosses on the housing

with the attaching holes on the Inside Plate Assembly. When Inside Plate Assembly is in

position with Housing install the (4) 8x32 Screws. Secure but do not over tighten screws.

Bauer Products, Inc.

702 Evergreen St SE

Grand Rapids, MI 49507

1-866-68-BAUER(22837)

(616) 245-4540

(616) 245-0131 fax

Bauer NE

Bauer NE - Quick Reference Card Manual

Other manuals for Bauer NE