1
UNPACK
Unpack your Smart Home Control Pack and check you have all the components:
• IR / RF Wi-Fi Controller
• Power Adapter
• Micro USB Cable
• RF Remote Control (batteries
included)
• 4 x Indoor Remote Controlled
Power Points
• Instruction Manual
• Getting Started Guide
• Warranty Card
Model Numbers: HE215041
GETTING STARTED GUIDE
2
SETTING UP THE RF POWER POINTS
1. Remove the tab from the rear of the remote control to activate the batteries.
2. Connect the device you wish to control to the socket of your power point controller.
3. Insert the Power Point Controller into any power outlet.
4. Turn on the power outlet. The LED on the Power Point Controller will begin to flash slowly.
5. Using the remote control, press the ON button next to the number you wish to assign the
Power Point Controller to.
6. Repeat steps 2-5 to pair remaining Power Point Controllers.
Note - The ON button will only need to be pressed once for successful pairing.
2.2 2.3 2.5
To Next Page
Need help?
General
