Reversing the door of your appliance
Caution! After unscrewing any of the fixing
hinges, hold the door to prevent it from falling
and causing damage.
Any parts that you remove from the appliance
whilst reversing the door, should be retained for
later use.
o WHILST SUPPORTING THE
DOOR. Unscrew the upper
hinge screws.
o On the bottom side of the
door unscrew the swing
stopper screws and remove
the stopper (A). Fix the
attached stopper with its
bearing on the opposite side
of the door.
o Unscrew the forced door closure system (B) and fix it to the
opposite side of the door (certain models only).
o Remove the door from the bottom
hinge.
o Unscrew the leg holder fixing screws.
o Tilt the appliance backward at a
maximum angle of 35° Unscrew the
leg support screws (C) - left and right,
and remove the leg support cover (D).
Then place it on the opposite side.
Unscrew, remove and then replace
the position of the end switch (E) and
decorative peg (F) (for models with
forced door closing system).
o Unscrew the three screws fixing the bottom hinge and then fix
the bottom hinge on the opposite side.
o To fit the door on the opposite side of the refrigerator proceed
with the above procedure in reverse. For ease of access to the
freezer compartment, you should also reverse the door on this
compartment.
To Next Page
Loading...
