o This appliance is supplied with a moulded plug, which must be
connected to an earthed socket.
29
ving 3 mm contact separation
and placed in an easily accessible position adjacent to the
icrowave is located in its housing.
o ured as follows:
Brown Live
As the colours of the wires in the appliance’s mains lead may not
oceed as follows:
he green and yellow wire must be connected to the terminal
When the connection is completed, no stray strands or cut wire
Broken or damaged power leads must only be replaced by a
b
i
inside or the outside
of the microwave), and that there are no packing
materials or accessories inside the cavity. Remove any
protective film on the microwave.
o If in future you need to change the fuse in this plug, then a 13 amp
ASTA approved (BS 1362) fuse must be used.
o If the earthed socket is not accessible after the appliance is
installed. Then the microwave must be wired into a 13 A double
pole switched fused spur outlet, ha
appliance. The spur outlet must still be accessible even when your
m
The wiring in the mains lead is colo
Blue Neutral
Green and yellow Earth
o
correspond with the coloured markings identifying the terminals in
your spur box, please pr
The brown wire must be connected to the terminal marked “L”
(live), or coloured red.
The blue wire must be connected to the terminal marked “N”
(neutral), or coloured black.
T
marked “E” (earth), or by the earth symbol, or coloured green and
yellow.
o
should be present. The cord clamp must be secured over the outer
sheath.
o
suita
used
ly qualified person. A power lead of a similar type must be
n replacement.
Before beginning to install your appliance, check that
there is no sign of damage (on the
To Next Page
Loading...
