Procedure of the commissioning
Instruction handbook b maXX (BM4-F-)DIO/FIO-XX (Digital IO module)
Document No. 5.01046.06 Baumüller Nürnberg GmbH
44
of 74
8.2
8.2 Procedure of the commissioning
The test-commissioning is divided into the following sections:
1 Recognition of the DIO/FIO-XX or BM4-F-DIO/FIO-XX.
2 Function test
8.2.1 Recognition of the Digital IO module
While starting, the control unit reads the identification of the Digital IO module automat-
ically.
After that, check with the help of ProDrive, whether the Digital IO module has been cor-
rectly recognized:
1 Switch on the b maXX 4000
2 Wait till the system has started
Eliminate any errors / error messages eventually existing in the b maXX 4000.
These errors might have been caused by faulty assembly (e.g. defective cable) or some
mistake(s) in installation (e.g. supply voltage absent). Only after having corrected the er
-
rors the commissioning can be continued.
NOTICE!
Environmental conditions that do not meet the requirements.
Environmental conditions that are non-compliant can lead to property damage.
Therefore:
m Ensure that the environmental conditions are kept compliant during operation (see
instruction handbook b
maXX 4000, operation conditions).
WARNING!
Risk of injury due to insufficient qualifications!
Inevitably, when operating this electrical device, certain parts of this device are ener-
gized with hazardous voltage. Improper handling can lead to significant personal in-
jury and material damage.
Therefore:
m Only qualified personnel may work on this device!
To Next Page
Loading...