Baumuller b maXX BM3400 Series - Error Parameters, Messages, and Reactions

T 8 Error detetion and trouble sho oting
8.5.2 Error parameters - error messages (error list) - error reations
All error messages are listed below. An (error) message is shown in WinBASS II in the window „Drive manager“.
In the list field „Messages“ you find the (abbreviated) error names, at HIPERFACE® error s also the device part,
the error number (not by err ors due to the HIPERFACE® specifications) and, separated by a colon, the mean-
ing of this error, e.g. MotorError 96: Short-circuit temperature sensor. At HIPERFACE® errors e.g. Encoder 1
communication: Parity error.
1. Level SysError1, only interesting for the access to errors via parameters, to be used without
WinBASS II, e.g. at field bus communication. This error is not shown in WinBASS II. Bit
mapping see description of the parameter P0200.
2. Level Next level below SysError1. Here you find errors, which you can remove directly with
help of the displayed information or also information on the next level in w hich the error
could be. The assignment of error messages took place ac c ording to «Structure of the
error list - survey» from page 126. In the column ’Reaction’ the systems reaction of the
syste to errors is to be found:
• PI = Pulse inhibit
• — = No reaction, the drive is operating and the decimal point is blinking.
• adjustable = The error reaction can be parameterized.
In the column „Troubleshooting“ you will find hints for troubleshooting: Further
information can be found in the Par ameter manual.
• ProcessorError (Errors in module processor) P0201
Error
no.
Mea ning Reaction Troubleshooting
0 Reserved
1 Watchdog-Error PI Restart b maXX® BM3400
2–15 Not assigned — —
128 Instrution Manual b maXX ® BM3400
from 206 Doument No.: 5.07013.03 Baumueller Kamenz GmbH