Baumuller b maXX BM3400 Series - Requirements for the Electrical Mains

T 6 Installation
6.3 Voltage hek
A voltage check according to EN 61800-5-1/VDE 0160, paragraph 5.2.3.2 and a checking of the protection
impedance according to paragraph 5.2.3.4. is made during the routine test of this device at Baumüller Ka-
menz GmbH.
WARNING
The following can occur, if the safety instruction is not complied with:
• serious personal injury
• death
The danger is: electricity.
Subsequent tests of the device with high voltages must be c a rried out only by Baumüller Ka-
menz GmbH.
If you are intending to check the complete switching cabinet installations with high voltage,
you must disconnect all cable connections from the Baumüller units before you start the test.
6.4 Requirements to the eletrial mains
All important data is to be found in «Appendix D - Requirements on the power supply» on page 171. Small
deviations of the electrical mains from the requirements can lead to malfunctions of the device. If the mains
strongly deviates from the requirements, the device can be destroyed. The destruction of the device can cause
personnel injury.
WARNING
The following can occur, if the safety instruction is not complied with:
• serious personal injury
• death
The danger is: electricity. In case you do not ensure the requirements to the electrical mains, the
device can be damaged/destroyed and can thereby endanger persons severely.
Assure before installation, that the requirements of the electrical mains are fulfilled.
56 Instrution Manual b maXX ® BM3400
from 206 Doument No.: 5.07013.03 Baumueller Kamenz GmbH