Installation procedure
Instruction handbook b maXX (BM4-F-)AIO-XX (Analog IO module)
Document No.: 5.01045.08 Baumüller Nürnberg GmbH
40
of 82
7.5
7.5 Installation procedure
1 Switch off the b maXX
4400 device and assure it against unintentional switching on
during mounting.
The connection cable of the Analog IO module must be made by the user, refer to ZRe-
quirements for the connection cables– auf Seite 38.
2 Take off the cover from the controller unit (when necessary)
3 Connect the cable with the suitable connector of the Analog IO module (cable goes
downwards)
4 Replace the cover again, if necessary
5 Laying of the cable in the control cabinet, refer to ZRequirements on the electrical con-
nection– auf Seite 38.
DANGER!
Risk of fatal injury from electrical current!
There is an immediate risk of fatal injury if live electrical parts are contacted.
Therefore:
m Switch off the current when any kind of work is being performed on the electrical
system and ensure safety before switching on again.
m Pay attention to the relevant safety instructions when handling electrical equip-
ment carrying high voltages.
m Do not touch electrically live parts before taking into account the discharge time of
the capacitors
To Next Page
Loading...
