45
of 70
Instruction handbook Mains filters BFN
Document No.: 5.09010.03
7INSTALLATION
This chapter describes the electrical installation of the device. The mechanical mounting
is described in ZMounting– from page 41
The technical preconditions must be complied with before installation:
1 Check the requirements to the power supply.
2 Check the requirements to the cables and the availability of the accordant cables.
3 Check the properties of the connections and the configuration of the cables.
7.1 Safety notes
NOTE!
Installation must be made by employees of the manufacturer or by other qualified per-
sonnel.
Qualified personnel are persons who – on account of their occupational training, ex-
perience, instruction and knowledge of relevant standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re-
sponsible for the safety of the facilities, to perform the respective activities that are
necessary. Qualified personnel must recognize and prevent potential risks. The qual-
ifications necessary for working with the device for example are:
m Occupational training or instruction, and the authorization to commission, ground
and mark electrical power circuits and devices in accordance with the standards of
the safety engineering.
m Occupational training or instruction, in accordance with the standards of work safe-
ty, for the care and use of appropriate safety equipment.
To Next Page
Loading...