There is a high amperage fuse that will blow if the windlass gets overloaded. The fuse is located
behind the backrest of the Nav station seat in the salon. There are six large fuses next to each
other; the anchor windlass fuse is the smaller of the six (second from left) and is 100 amps.
You can tell if the fuse is blown by the tab that pops up. Compare the fuse you have removed
with the one in the chart table. To replace, first turn windlass switch off on the 12v panel, pull
the blown fuse straight out and replace with the new one that is located in the chart table.
If you have any doubts or concerns, please call Horizon first. Before replacing the fuse,
however, ensure that the windlass breaker on the 12v panel is switched on, and that the green
light is not illuminated. If it is illuminated, this indicates that the fuse is NOT blown, and that the
yacht battery power is too low to run the windlass. Please run the engine @1500 rpm for 15
min, and try again. If the windlass still refuses to operate, please call horizon.
To Next Page
Loading...
