Need help?Do you have a question about the Bavarian Demon AXON and is the answer not in the manual?
General| Type | Flybarless System |
|---|---|
| Supported Models | Helicopters |
| Weight | 18 g |
| Sensor Type | 3-axis Gyro, 3-axis Accelerometer |
| Vibration Analysis | Yes |
| Telemetry Support | Yes |
| Governor | Yes |
| Rescue Function | Yes |
| Current Consumption | 50mA |
| Firmware Update | Via USB |
| Connectivity | S-Bus |
| Operating Temperature | -10°C to +60°C |
Basic setup and any tuning needs to be carried out using the corresponding setup software.
Connect each cable of the cable loom to the appropriate channel on the receiver, according to the diagram.
Connect Rx to port B using a patch cable, or connect Spektrum satellites on the side ports (Master/Slave).
Basic setup needs to be carried out using the software. This can be done 'manually' (Expert mode) or wizard-guided.
Describes LED status during initialization and operation, including error codes and gyro modes.
Defines head gyro sensitivity and bank switching based on signal travel.
Controls tail gyro sensitivity and mode (Normal/Heading-Lock) based on signal travel.
Verify that control surface movements oppose the direction of model tilt.
Recommendations for the maiden flight, starting with default settings and gradual gain increases.
To Next Page
