Need help?Do you have a question about the Bayer HealthCare RapidPoint 400 Series and is the answer not in the manual?
General| Type | Blood Gas Analyzer |
|---|---|
| Measured Analytes | pH, pCO2, pO2, Na+, K+, Ca++, Cl-, glucose, lactate, hematocrit, CO-oximetry (tHb, O2Hb, COHb, MetHb, HHb) |
| Weight | 22 kg (48.5 lbs) without reagents |
| Sample Types | Whole blood, plasma, serum |
| Analytes | pH, pCO2, pO2, Na+, K+, Ca++, Cl-, glucose, lactate, tHb |
| Measurement Parameters | pH, pCO2, pO2, Na+, K+, Cl-, Ca++, Glucose, Lactate, tHb |
| Measurement Time | Approximately 60 seconds |
| Connectivity | Ethernet, USB |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Calibration | Automatic |
| Operating Temperature | 15-30°C |
| Design | Benchtop |
Explains text and symbol conventions used throughout the manual.
Describes symbols found on the system exterior for component location and operation warnings.
Describes the mechanical components of the Rapidpoint 400 series systems.
Details the self-contained measurement cartridge, its fluidic components, reagents, and sensors.
Describes the self-contained AutomaticQC cartridge for performance verification.
Details the CO-oximeter measurement module for analyzing hemoglobin fractions in blood.
Describes the electronic systems and circuit descriptions for Rapidpoint 400 series printed circuit boards.
Details the Contact PC board's function in amplifying electrode signals and providing bias amplifiers.
Explains the Main PC Board's role in system requirements, real-time processing, and data acquisition.
Includes four system diagrams: menu map, fluidic diagrams, electronic block text, and cable interconnect diagrams.
Provides detailed illustrations and specifications for various system cable assemblies.
Procedure for performing 1-point, 2-point, or full system calibrations.
Procedure to calibrate the touch screen when it responds inconsistently.
Identifies probable causes and corrective actions for common system issues.
Lists system messages, their probable causes, and corrective actions.
Describes how to print diagnostic reports and use diagnostic tests for system evaluation.
Illustrations of the main system assemblies with numbered parts.
Lists main assembly parts with manufacturing and service part numbers.
Illustrations of the cartridge interface assembly and its components.
Lists parts for the power module assembly with manufacturing and service part numbers.
Procedure for replacing the sample port due to problems or system prompts.
Procedure for replacing the CO-ox halogen lamp for proper operation.
Procedure for replacing the power supply module of the system.
Describes the procedure for the initial installation of the Rapidpoint 400 series system.
Describes methods to connect the system to a Rapidlink data management system.
Procedure to connect the system to a hospital or laboratory information system (LIS).
Procedure to create a Setup disk and capture system information.
Procedure for installing the new Rapidpoint 400 series system.
Steps to complete the Rapidpoint setup after installation.
Describes the two modes of operation: FOR DEMONSTRATION ONLY and USER mode.
Explains how to determine if the system is in USER mode or FOR DEMONSTRATION ONLY mode.
Details the three types of calibrations: 1-point, 2-point, and full 2-point.
Outlines the schedule for 1-point, 2-point, and full 2-point calibrations.
To Next Page
