CHAPTER 3: COMPONENTS/SYSTEMS 23
Capri 21’ - 23’ • Owner’s Manual Supplement
If the bilge pump hose is not the problem, check the bilge pump housing for clog-
ging debris as follows:
To remove the power cartridge:
1. Lift the tab while rotating the fins
counter clockwise and lift out the
power cartridge (Fig. 1).
2. Clear the housing of debris.
To reinstall the power cartridge:
1. Make sure the “O” ring is properly
located and coat the “O” ring with
a light film of vegetable oil or min-
eral oil (Fig. 2).
2. Align the two cams on either side
of the power cartridge with the two
slots on the outer housing. Press the
power cartridge into the housing
and twist clockwise. Ensure proper
reinstallation by attempting to twist
the fins counter clockwise without
lifting the tab. The cartridge should
stay in place.
FIG. 1
TAB FIN
FIG. 2
OF OIL
LIGHT FILM
“O” RING
POWER
CARTRIDGE
NOTICE
Discharge of oil, oil waste or fuel into navigable waters is prohibited by law.
Violators are subject to legal action by the local authorities.
To Next Page
Loading...
