Need help?Do you have a question about the Bazooka ELA150.1 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Minimum Impedance Unbridged | 2 Ohms |
| THD at Rated RMS Power | <1% |
| Signal to Noise Ratio | >90 dB |
| Input Sensitivity | 200mV - 6V |
| Fuse Rating | 25A |
| RMS Power at 4 Ohms | 150W |
| Bass Boost | 0 to +12 dB |
Ensure the power wire is fused within 12 inches of the battery for protection.
Use high-grade connectors for maximum power transfer and secure connections.
Avoid running wires underneath the vehicle; use interior panels for cleaner installation.
Exercise caution when mounting to avoid puncturing vehicle lines or gas tanks.
Run signal wires away from electrical wires to prevent induced noise.
Keep ground wires short and connect all units to the same ground point.
Protect wires from sharp edges using grommets to prevent shorts.
Protects speakers from DC voltage by shutting down the amplifier.
Protects the amplifier from speaker or wiring shorts.
Shuts down the amplifier to prevent damage from high temperatures.
A green LED illuminates when the amplifier is powered on.
Allows running stereo and mono configurations simultaneously.
Variable high and low pass crossovers for frequency filtering.
Output for daisy-chaining another Bazooka Amplified Bass Tube.
Heavy gauge blocks for maximum power and signal transfer.
Variable 0-12 dB bass boost at 45Hz for enhanced low frequencies.
Full range line outputs for connecting additional amplifiers.
Protects against short circuits and excessive current.
Automatically turns the amplifier on/off with the head unit.
Fine-tunes level matching between source and amplifier.
Connects to radios without low-level outputs (factory systems).
Stable operation at 2 ohms stereo mode and 4 ohms bridged.
Connect amplifier's +12V terminal to the car battery using appropriate gauge wire.
Connect the GND terminal to the car chassis using short, clean wire.
Connect the REM terminal to a switchable +12V source for turn-on.
Wiring for connecting to a floating ground radio system.
Wiring for connecting to a common ground radio system.
Specific high-level wiring for ELA/MAA60.4 with floating ground.
Specific high-level wiring for ELA/MAA60.4 with common ground.
Adjust gain sensitivity to match radio output without distortion.
Common causes for no audio output and their solutions.
Troubleshooting steps for reduced audio volume.
Resolving inducted electrical and engine noise.
Diagnosing problems indicated by the red protection LED.
Identifying reasons for amplifier overheating.
To Next Page