BBH SMX 12-2 - 7.4 LED display

Installation manual
HB-37350-810-01-51F-EN SMX Installation manual.docx Page 191 of 234
Version: 50F
7.4 LED display
Colour
Mode
Description
green
"flashing"
System OK, configuration
validated
yellow
"flashing"
System OK, configuration
not yet validated
red
"flashing"
Alarm
red
"permanent"
Fatal Fault
yellow - red
"flashing"
System OK, configuration
not yet validated, SMMC
configured however participant is
missing
green - red
"flashing"
System OK, configuration
validated, SMMC configured
however participant is missing
Note:
For all operating states except RUN the outputs are rendered passive by the firmware, i.e.
safely switched off. In status RUN the state of the outputs depend on the implemented PLC-
program.