BBH SMX Series - Page 217

Installation manual
HB-37420-810-01-25F-EN SMX100 Installation manual.docx Page 217 of 260
Version: 25F
*) if bus system (slave module) is configured, the following display is applicable for the operating
mode
There may be bus errors when using SMX100 with slave modules. Descriptions of the individual
bus status messages are as follows:
Display
Description
Impact on the
system
Reset condition
b0003
Initialization/synchronization with
slave module.
All outputs are
switched off!
Can be reset by
switching on/off
the master
module (POR).
b0008
Transfer of configuration data to the
slave module.
All outputs are
switched off!
Not required
b0010
Bus in “RUN”
All outputs are
active!
Not required
b0012
Bus error
All outputs are
switched off!
Can be reset
through
parametrisable
input or by
switching on/off
the master
module (POR).
b0012 -
Fxyyyy
Slave device x has a Fatal Error yyyy
and cannot be registered in the
SDDC bus system
All outputs are
switched off!
Can be reset by
switching on/off
the slave module
(POR).
In case of error, the bus status can be permanently stuck in status "b0003" or "b0012".
The error cases are as follows: