BCP SKY2425 - Securing the Safe Installation; Safe Mounting Procedure; Anchor Bolt Usage and Tightening

| 7
1/4 inch
SECURING SAFE
To secure the safe, use four part 1 sleeve anchors to attach the safe to the wall or floor.
Drill four holes into the wall/floor.
- Drill approximately a ¼” deeper than the length of the sleeve anchor.
Insert four sleeve anchors into the holes.
- Use a hammer if necessary.
Tighten the nuts to secure the sleeve anchors in the wall/floor.
1.
2.
3.
1
x4