To Next Page
E
Erik StoutAug 17, 2025
How to fix a BE Ag & Industrial Cutter that leaves streaks?
- MMichael HaleAug 17, 2025
If your BE Ag & Industrial Cutter leaves a streak of uncut or partially cut grass, consider the following: * Ensure the 3-point hitch linkage on your tractor is level. * Sharpen or replace the blades. * Use the correct PTO speed. * If the grass is too wet, stop and wait for drier conditions. * Reduce ground speed by shifting to a lower gear. * Free the blades. * Replace the blade bolts. * Try mowing in one direction, cleaning the mower, and then mowing again in the opposite direction. * Clean the mower. * Mow with enough overlap, offsetting the mower to the left 4”-6” by adjusting stabilizer bars to re-cut the tire track from the previous pass.
General