1. Earth
2. Signal –
3. Signal +
CONNECTIONS
First connect all signal leads prior to connecting the mains lead to a mains outlet!!
Connection if several moving heads must operate together (Master/Slave):
Connect the moving heads via 3-pin XLR leads as indicated in the illustration above if you want to
operate them in Master-Slave mode.
The wiring of an XLR connector is indicated below:
An end-of-line resistor of 120Ω/1W must be connected on the last
unit of the chain (DMX OUT between pin 2 & 3).
DMX512 PROTOCOLE
5 CHANNEL MODE
Channel 1: Pan, The moving head can rotate horizontally up to 540° and stop in any position.
Channel 2: Tilt, The moving head can rotate vertically up to 270° and stop in any position.
Channel 3: Shutter and stroboscope Channel 4: Colours
0-7 Closed
8-21 Open / White
22-35 Red
36-49 Green
50-63 UV
64-77 Light blue
78-91 Pink
92-105 Yellow
106-119 Magenta
120-133 Pink II
134-147 Light green
148-161 Light Magenta
162-189 Dark blue
190-203 Light pink
204-217 White II
218-231 White III
232-255 Rainbow effect
0-9 Shutter closed
10-134 Shutter open 0-100%
135-239 Stroboscope (slow to fast)
240-255 Shutter open
I
OUT
I
OUT
I
OUT
DMX
IN
DMX
OUT
To Next Page
