13
EN
Dehumidier | Deshumidicador | Desumidicador
• All wiring must be performed strictly in accordance with the wiring
diagram located on the middle bale of the unit (behind the water
collector).
Note on the fuse
The unit’s circuit board (PCB) is designed with a fuse to provide
overcurrent protection. The specications of the fuse are printed on
the circuit board, such as: T 3.15A/250V (or 350V), etc.
NOTE: All gures in this manual are for illustration purposes only. The
actual shape of the unit you purchase may be slightly dierent, but the
operations and functions are the same.
Note on Fluorinated Gasses
• Fluorinated greenhouse gases are contained in hermetically sealed
equipment. For specic information on the type, the amount and
the CO2 equivalent in tonnes of the uorinated greenhouse gas (on
some models), please refer to the relevant label on the unit itself.
• Installation, service, maintenance and repair to this dehumidier
must be performed by a certied technician.
• Product uninstallation and recycling must be performed by a
certied technician.
• Do not use means to accelerate the defrosting process or to clean,
other than those recommended by the manufacturer.
• The appliance shall be stored in a room without continuously
operating ignition sources (for example: open ames, an operating
gas appliance or an operating electric heater).
• Do not pierce or burn.
To Next Page
Loading...