9
EN
Stand fan | Ventilador de pie | Ventoinha de pé
2.2. Using the Product
Assembly
• The appliance must be fully assembled before use.
• Place the vertical support into the base and tighten the screw in the
lower part of the base.
• Loosen o the vertical adjustment screw and pull the extendable
handle to adjust the fan until it is at the desired height then tighten
the screw.
• Insert the fan housing into the extendable handle and tighten the
screw.
• Insert the rear grill through the motor shaft, ensuring the plastic pins
on the grill snap into the holes in the motor housing.
• Secure the grill in place by turning the plastic nut clockwise.
• Insert the large fan blade into the motor shaft, then insert the small
fan blade in an anti-clockwise direction.
• Fix the front grill to the rear grill and close using the xing hook.
• Adjust the angle of the fan before switching it on.
Remote control
• Insert two batteries (1.5A AAA type) into the remote control and
close the battery cover by clicking it into place.
• Ensure there are no objects in the way that can obstruct the signal.
• Remove the batteries from the remote control if you do not use it for
an extended period of time (four or more weeks).
AF Manual VENTOINHA PÉ BSF2771 A5 EN.indd 9 31/03/17 18:45
To Next Page
Loading...
