987892AF
xi
Safety Notice
Warnings and Cautions Found in this Manual
WARNING
Turn off power to the Biomek NX instrument before attaching or removing
AccuFrame from the instrument deck.
WARNING
Make sure the light curtain is not violated by the AccuFrame cable. If the light
curtain is violated, the framing process halts immediately.
WARNING
Make sure the AccuFrame cable does not interfere with pod movement.
CAUTION
Use Shift deck only before other ALPs or positions are taught. Shift deck shifts all
ALPs and positions, resulting in incorrect coordinates if applied to previously
framed ALPs and positions.
CAUTION
Select Move Z-Max to move the pod to its highest point before extending the
gripper. To avoid breaking labware or bending the gripper fingers, make sure the
gripper fingers will not hit any labware when extended.
CAUTION
Do not retract gripper when it is holding labware.
WARNING
CLASS II LASER PRODUCT
THIS PRODUCT CONFORMS TO APPLICABLE REQUIREMENTS OF 21 CFR 1040 AT
THE DATE OF MANUFACTURE.
CAUTION
To avoid serious damage to the instrument, make sure that the laboratory site
voltage/frequency matches the voltage/frequency that was ordered for the
instrument.
WARNING
Do not attempt to remove or replace covers while the unit is powered on.
Disconnect power before removing or replacing a cover.
To Next Page
Loading...
Need help?
General
