Operating Manual | EMS-58 | Beckmann GmbH
Connector layout
N,L
Mains input (230V/50-60 Hz)
L´
Device output (230V, 50-60 Hz, 16 A max.)
3.3 Maintenance
The devices of the EMS 58 series are nearly maintenance-free. Only the coin selector has
to be cleaned sometimes, in order to guarantee a proper operation.
4 Operation
After final programming a time sale can be effected with the EMS 58. The following
description refers to factory default programming of the EMS 58.
4.1 Time selling
The EMS 58 has a 3-digit LED-Display, that shows the customer the current state of the
device. A survey you can find in the following figure.
Figure 3: Display reports
Before starting the payment, the device must be free, i.e. the display must show ”0”. After
insertion of the first coin, the EMS 58 indicates the released time. As far as the minimum
insertion is not achieved, the time is indicated flashing. When the min. insertion is
achieved by inserting a further coin, the display does not flash any more and the device
starts. If further coins are inserted, the currently released time is indicated. During the risk
of an overpayment, i.e. by inserting the next coin the maximum time would be exceeded,
the EMS 58 signals a warning by indicating the time and ”0” alternating. If the maximum
time is achieved, the coin selector will be blocked and additional coins can not be
inserted anymore.
CAUTION:
In case of overpayment, the overpaid amount of money will be lost
(additional time will not be added beyond the maximum time). The coin
counter however will register all the money.
While the time runs down, the decimal point will blink and the displayed time will
decrease by one every minute that expires. During the last minute the display changes
Page 6
To Next Page
Loading...