Beef Eater Bugg STAND - Assemble Front leg; Assemble Back leg

3
ASSEMBLY:
1. Assemble Front leg:
[ 4 x A, 4 x B ]
Place the Leg (1) on a padded flat, level surface and assemble the two Front Shelf Brackets (3).
Insert two Silicone Feet (6) to the bottom hole, and pull until rest against bottom of leg.
2. Assemble Back leg:
[ 8 x A, 8 x B ]
Place other Leg (1) on a padded flat, level surface and assemble the Wheel Brackets (4) and Cylinder Hook (5).
Insert two Silicone Feet (6) to the bottom hole, and pull until rest against bottom of leg.
Note: at this stage each Wheel Bracket is only attached by 2 lower screws!