loosen the shoulder harness (see
point 6.2).
Pull out the buckle tongues from the
chest pad and the slots on the cover and the
shell, then thread them into the
corre-sponding belt slots.
pressing the lever (under the seat cover) on
the front of the seat.
you grip the two shoulder straps with your
other hand. Pull the shoulder straps towards
you to loosen it.
1.Firstly, adjust the shoulder straps height (see point 6.1),proceed as
follows.
2.Loosen the harness(see point 6.2),open the buckle, and place them
down sideways. Seat your child in the child car seat. Place both
shoulder straps over your child’s shoulders.
4.Ensure that the straps are close to the should of the child by pulling
-Too high
-Too low
6.Securing your baby
Check whether the shoulder belts are set at the right height for
your child.The shoulder belts should be fed into the belt slots
that lie at shoulder height or just above.
Fig.1 Fig.2 Fig.3 Fig.4
press
The handle for the baby car seat can be
To adjust the handle, please press the
To Next Page
Loading...
