6 - TROUBLESHOOTING
WARNING: Be sure tractor engine is off, parking brake is locked, and key is
removed before making any adjustments.
Check slip clutch.
Check oil level in gearbox.
Slip clutch slipping.
Gearbox oil low.
Machine smells hot or
begins to smoke.
Allow material to dry.
Raise cutting height.
Reduce ground speed.
Make two passes to cut.
Material is too wet.
Material is too high.
Material bunching.
Remove wrappings.
Check tractor PTO speed.
Replace blades with identical
pairs (the same weight).
Wrappings around blades.
Improper tractor PTO speed.
Unbalanced blades.
Vibrations.
Check tractor PTO speed.Cutter is not working at the
proper PTO rpm speed.
High wear on blade
mounting holes
(blade bolts).
Raise cutting height.Blades hitting ground.High wear on blades.
Tighten hardware.
Add oil to gearbox.
Loose hardware.
Gearbox oil level is low.
Cutter is noisy.
Remove wrappings.
Adjust three point hitch to level
out the cutter.
Check tractor PTO speed.
Check slip clutch.
Wrappings around rotor.
Cutter is not hooked up level.
Tractor PTO speed too slow.
Slip clutch slipping.
Material not cut or
laid over.
Adjust three point hitch to level
out the cutter.
Replace blades.
Cutter is not hooked up level.
Blades are worn or bent.
Irregular cut.
SOLUTIONPOSSIBLE CAUSEPROBLEM
TROUBLESHOOTING 34 BEFCO
T
ORNADO RSD & RRB OPERATOR’S MANUAL
To Next Page
Loading...