BEFCO TORNADO RSD-142 - 2.02 - Starting and Stopping; 2.03

To Next Page

To Previous Page

8. Ensure that all safety shielding and safety signs are properly installed and in good

condition.

2.02 - Starting and Stopping

1. Be sure that no one is near the machine prior to engaging or while the machine is

working.

2. Be sure the tractor is in “Neutral” before starting engine.

3. Mower operating power is supplied from tractor PTO. Refer to your tractor manual

for PTO engagement and disengagement instructions. Always operate PTO at 540

rpm. Know how to stop the tractor and mower quickly in case of an emergency.

4. When engaging PTO, the engine rpm should always be low. Once engaged and

ready to start cutting, gradually raise PTO speed to 540 rpm and maintain

throughout cutting operation.

5. Check the tractor master shield over the PTO stub shaft. Make sure it is in good

condition and fastened securely to the tractor. Purchase a new shield if old shield is

damaged or missing.

6. If the driveline you are using is equipped with a slip clutch, ensure that the metal slip

clutch shield is properly mounted to the gearbox and in good condition.

7. After striking an obstacle, disengage the PTO, shut the tractor down and thoroughly

inspect for damage before restarting.

8. Never engage the PTO until the cutter is in the down position and resting on the

ground. Never raise the cutter until all blades have come to a complete stop.

9. To park the vehicle safely, stop vehicle on a level surface (not on a slope),

disengage PTO, engage the parking brake, stop the engine, remove the key, and

wait for engine and all moving parts to stop before leaving the operator’s seat.

10.Stay clear of rotating drivelines. Entanglement in rotating driveline can cause serious

injury or death. Wear close fitting clothing. Stop the engine and be sure PTO

driveline is stopped before getting near it.

2.03 - Messages and Signs

1. Read and adhere to all safety and operating decals on this machine (see fig. 2).

2. Before dismounting tractor: Allow moving parts to stop, stop engine, set brake and

remove the key of unattended equipment.

3. Keep away from rotating blades and driveline.

4. Keep guards and shields in place and in good condition.

5. Do not mow with bystanders in area.

6. Allow no riders on tractor or mower.

7. Allow moving parts to stop before repair.

SAFETY PRECAUTIONS 7 BEFCO

ORNADO RSD & RRB OPERATOR’S MANUAL

BEFCO TORNADO RSD-142 - 2.02 - Starting and Stopping; 2.03 - Messages and Signs