Bego Eltropol 300 - Polishing Time and Current Adjustment

English ⋅ Eltropol 300
33
85955 BA-en/11
en
Polishing
1. Switch on the unit using the main switch:
• 1 alarm tone;
• display briefly shows the software version,
then 0:00;
• heating the bath: the 5 LEDs light up in suc-
cession - "chaser" effect. After a maximum
of 25 minutes the operating temperature of
approx. 40 °C is reached: the LEDs go out.
2. Secure object to be polished.
3. Press the Start button:
• the display indicates the polishing time cal-
culated by the unit (according to object size
and bath temperature). The polishing time
can also be altered using the plus or minus
keys.
4. Start polishing: press the Start button again.
• the remaining polishing time is indicated on
the display (countdown meter);
• the strength of current during polishing is
indicated by the 5 LEDs. The current
strength can also be altered using the plus
or minus keys as required.
5. After polishing:
• triple alarm tone;
• display shows 0:00.
6. Remove the object holder with the polishing
object and rinse off under running water.
WARNING
• Avoid contact with skin and eyes!
Risk of blinding!
• Wear safety glasses and safety
gloves!
Never add water!
WARNING
Only operate the unit when it is
closed.
The fumes are a health hazard.