F&E Equipment
Service manual V1.0 Gelovit 200
Autor : Fin/DW Stand 11.02.09 Seite 2 von 6
This handbook describes functions, which are not described in the manual of the device. It
is only valid for Gelovit 200 with brushless drive.
1. Commissioning
The device shows first the software version in the display and then the unit of the tempera-
ture in °C or °F.
2. General notes
The motor starts running at a specified temperature of 50°C/122°F and is accelerated and
braked by ramps. The speed of the motor and the fan is controlled by the software. The
heating circuits are proportionally controlled to the required performance.
To Next Page
Loading...
