Bego Gelovit 200 - Special Safety Instructions; Burn Hazard from Hot Parts

- 17 -
Gelovit 200
Operation
Switching on and duplicating
1 Switch on main power switch on right side of unit.
2 Display shows actual temperature of the
duplicating material.
3 Press T1 (see notes).
After the desired temperature is reached:
4 Place flask under the outlet.
5 Open cock to the left. Close cock. Remove and
collect duplicating material after hardening.
Notes:
z Press T1: duplicating material is melted and
subsequently cooled down to operating temperature.
Duration with 6 kg of duplication material: approx.
4 hours.
Lamp T1 is constantly lit: melting.
Lamp T2 flashes (or is constantly lit): operating
temperature not yet reached (or has been reached).
z Press T3 after operating temperature has been
reached: duplicating material is cooled down to the
reduced operating temperature - and is heated up to
operating temperature again 20 minutes later.
Lamp T3 flashes (or is constantly lit):
reduced operating temperature not yet reached
(or has been reached).
z The number of previous melting operations is
displayed for approx. 5 seconds when the " " button
is kept depressed (until acoustic signal sounds twice).
Attention: The last recommended melting operation
is indicated by the flashing °F lamp (or °C lamp when
°F is set). In addition, an acoustic signal sounds for
approx. 30 seconds. - Duplicate as usual. Discharge
the duplicating material before switching off the
unit.
Do not forget: After filling with fresh duplicating
material, reset the counting mechanism for melting
operations to 0 by holding down the "-" button (until
the acoustic signal sounds twice)!
z The number of recommended melting operations
can be adjusted according to the duplicating material
used:
- Hold down the "+" button until the acoustic signal
sounds twice: the display shows the number of
recommended melting operations (basic setting: 8).
- Change the value by means of "+" and "-" buttons.
- The value is stored after 10 seconds or by holding
down the "+" again (until the acoustic signal
sounds twice).
1
2 2
3
2
°C
°F